Make Lanyard Holes On Your I Phone Case

Many cell phones have lanyard holes built right in. These holes are used to attach a lanyard or other strap to prevent damage, loss or theft. They can also be used to attach decorations, such as cell phone charms. Unfortunately, the iPhone does not have lanyard holes, but you can build your own into a silicone phone case.

1. Put a silicone iPhone 5 case on your iPhone.

2. Draw two tiny dots centered on the top edge of the case, with a space of 5 mm in between the dots.

3. Remove the case from your iPhone.


4. Poke a hole using a 2 mm craft punch over each dot you just drew.

Tips & Warnings

Make sure to use a lanyard specifically made for cellphones, since the straps are much smaller than on standard lanyards. A wrist strap for a digital camera works as well. If you don’t want to poke holes in your best iPhone 4 case, you can sew a button on it and tie the lanyard straps around the button.

How to Open an iPhone 3G’s Case

1. Unfold a paper clip and use one end to pry up your SIM card from the top of your iPhone.

2. Unscrew the two small screws to the side of the dock on the bottom of the iPhone. Set them aside and don’t lose them.

3. Insert the tip of the exacto knife directly above one of the screw holes and begin applying a slight amount of pressure to pry up the glass top.

4. Wiggle slightly up and down to loosen the upper panel from the lower panel. Once it’s released on the bottom, grab both sides of the dock end and lift up slowly. It lifts like a panel — be careful not to pull the top end off completely or disconnect the ribbons at the top end.

Article Source:

About Author:

Espow offer electronics for best iphone 4 case, car dvr. In addition, we also sells a kinds of beautiful oil paintings. We aim at offering the most updated and high quality consumer products to web shoppers from all over the world while shoppers can experience a comfortable and secure shopping process on the web.Author: Yong Cheng